Neighbours generally split a sufficient dividing fence 50/50. If you want a higher standard, you pay the extra.
Typical contribution
50/50
Dividing Fences Act 1991 (NSW)
NoticeServe a fencing notice. If there's no agreement within one month, either owner can apply to NCAT or the Local Court.
UpgradeRequesting owner usually pays the extra
01How to start
How to start a dividing fence
Talk with your neighbour about the boundary, materials and cost.
Give the required fencing notice and allow the response period.
Get written quotes and agree on the work before installation.
If you cannot agree, follow the state dispute process in the official wording.
02Other rules
Other New South Wales dividing fence rules
Read the official wording
Bushfire zones
For a fence to be exempt development on bush fire prone land it must be built of non-combustible materials (or hardwood, under the exempt rules for most zones). Check whether a lot is mapped as bush fire prone on the NSW Planning Portal; new building work there must follow Planning for Bush Fire Protection and AS 3959.
In zones R1–R4 and RU5, a fence along, or in the setback area of, a primary or secondary road (including the side boundary on a corner site) is exempt only up to 1.2 m. Along a secondary road it must be at least 20% transparent above 400 mm, with no solid piers or posts wider than 350 mm. Higher front fences need a complying development certificate or a DA.
In rural, environmental and R5 zones, exempt fences may be up to 1.8 m and must be post and wire or post and rail; masonry only within 3 m either side of the property entrance from the primary road. Electric fencing must meet AS/NZS 3014.
In zones R1, R2, R3, R4 and RU5, side and rear boundary fences are exempt development (no DA) up to 1.8 m, or 1.2 m if masonry. Gates must not open outwards; metal parts must be low-reflective factory pre-coloured; no electric or barbed wire fences in residential zones. Exempt development does not apply on heritage items, flood control lots or foreshore areas.
Every pool or spa must be registered on the NSW Swimming Pool Register. Barriers must generally be at least 1.2 m high with gaps no more than 10 cm, under the Swimming Pools Act 1992 and AS 1926.1. To sell, the contract must include the registration certificate plus an occupation, compliance or non-compliance certificate; to lease, a valid compliance or occupation certificate is required. Inspections are by council or an accredited certifier.