Australian Capital Territory · Common Boundaries Act 1981 (ACT)
Who pays for a dividing fence in Australian Capital Territory?
Neighbours each pay half of a basic fence (1.5 m hardwood paling). Anything else needs both neighbours to agree first.
Typical contribution
50/50
Common Boundaries Act 1981 (ACT)
NoticeTalk first and give a notice to discuss the fence. If you can't agree, use the free Conflict Resolution Service or apply to ACAT.
UpgradeRequesting owner usually pays the extra
01How to start
How to start a dividing fence
Talk with your neighbour about the boundary, materials and cost.
Give the required fencing notice and allow the response period.
Get written quotes and agree on the work before installation.
If you cannot agree, follow the state dispute process in the official wording.
02Other rules
Other Australian Capital Territory dividing fence rules
Read the official wording
Front fence height limits
Instead of a front fence, a courtyard wall may be built forward of the building line if it meets the Single Dwelling Housing Development Control: generally between 1.5 m and 1.8 m high, of brick, block, stonework or render (timber or metal panels allowed with at least 25% openings), with limits on its length relative to the block width and a minimum front setback. The advisory note says around 1.5 m is generally expected where facing streets or public spaces.
Canberra has a long-standing policy of no front fences forward of the building line in residential areas, to keep the garden-city streetscape. Exceptions are an outcome set by an estate development plan or subdivision design, a relevant district policy, a compliant courtyard wall, or exempt development. Hedges and low demarcation (up to 400 mm) are allowed.
Where a block’s development requirements call for a fence to an open space boundary, it is exempt if no higher than 1.85 m and either a basic paling fence or prefinished unperforated metal sheet (e.g. Colorbond-type) used to the maker’s instructions.
A fence or freestanding wall is exempt from development approval if panels are no higher than 2.3 m and posts no higher than 2.5 m above datum ground level, no part is between the front boundary and the building line, it does not divert surface water onto other land, and it meets the general exemption criteria. Mesh fences in industrial zones can be 2.7 m. Repairing or replacing a fence like-for-like is also exempt.
Under the home swimming pool safety reforms, from 1 May 2028 every home pool and spa in the ACT must have a safety barrier meeting the prescribed standards (for pools built before 1 May 2023: current BCA plus AS 1926.1-2012 and AS 1926.2-2007). Since 1 May 2024 owners must maintain barriers and keep gates, doors and covers closed.
A pool barrier inside the property should be at least 1.2 m high all round (measured outside the pool area) with a 90 cm non-climbable zone, no more than 10 cm ground gap, no openings over 10 cm, and self-closing, self-latching gates. A boundary fence forming part of the barrier should be at least 1.8 m high measured from inside the pool area. Barriers must meet the NCC and AS 1926.1-2012; a pool needing building approval cannot be used until a certifier has checked it and a Certificate of Occupancy and Use is issued.